Addictive Desert Designs 2010 - 2014 Ford Raptor Fender Inner - Manual

–
1. Disconnect the negative terminal on the battery. With the vehicle on level ground and the
emergency brake set.
2. You will need the following tools:
a. 1/8" drill bit
b. 3/16" drill bit
c. Grinder
d. Cut off Wheel for grinder
e. Power Drill
f. Phillips head Bit attachment
g. Rivet gun for 3/16" rivets
h. 10mm socket
i. 8mm socket
j. 5.5mm socket
k. Ratchet
3. Hardware Included:
a. 3 - Mounting Tabs (1 each Small, Medium and Large)
b. 10 - Self Tapping Screws
c. 12 - 3/16" Rivets
d. 12 - fender washers
1. Remove factory Front Fenders and Fender Inners.
2. Mark front valance for trimming ( 1.75"
on top and 3.00" on bottom) and cut as
in image at right.