Snorkel LX41 Electric-sn4022-4390 - Manual (Page 13)

Maintenance
067449-002 LX Electric Work Platform - Operator Manual Page 11
M
AINTENANCE
B L O C K I N G T H E E L E V A T I N G A S S E M B L Y
Figure 8: Blocking Elevating Assembly
W A R N I N G ! !
Never perform service on the machine in the elevating assembly
area while the platform is elevated without first blocking the
elevating assembly.
DO NOT stand in elevating assembly area while deploying or
storing brace.
B RACE I NSTALLATION
1. Park the machine on firm, level ground.
2. Verify that the platform Emergency Stop Button is ON.
3. Turn the Platform/Chassis Switch to CHASSIS.
4. Using the Raise Button, elevate the platform until the scissor
brace can be rotated to the vertical position.
5. From the left side of the machine, disengage the locking pin
securing the brace. Rotate the scissor brace counterclockwise
until it is vertical and between the two scissor center pivots.
6. Push the Lower Button and gradually lower the platform until the brace is supporting the platform.
B RACE R EMOVAL
1. Using the chassis controls, gradually raise the platform until the scissor brace clears the two scissor cen-
ter pivots.
2. Rotate the scissor brace clockwise until the locking pin engages.
3. Push the Lower Button to completely lower the platform.
H Y D R A U L I C F L U I D
Figure 9: Hydraulic Fluid Reservoir
The hydraulic fluid reservoir is located in the Power Module.
NOTE: Never add fluid if the platform is elevated.
1. Make sure that the platform is fully lowered.
2. Check fluid level by observing the fluid sight gauge
3. Remove the filler cap to fill with the appropriate fluid.
Lower Scissor
Center Pivot
Upper Scissor
Center Pivot
Brace
Locking Pin
2
1
1. Fluid Sight Gauge
2. Filler Cap