Snorkel PAM26-sn0001+ - Manual (Page 28)

Page22
December 2008 Instruction Manual
9.4 Problem 4 – Leakage of the hydraulic oil
9.4.1 Check all piping connections for their tightness, and tighten up if necessary.
9.4.2 Check whether the viscosity of the used hydraulic oil is too low or not.
9.5 Problem 5 – All the indicator lights are on, but the platform couldn‘t rise or fall.
Check the Emergency stop switches on both upper and lower control device.
Reset the switch by turning the knob in the direction shown by the arrow.
Chapter 10 Electric Schematic and Hydraulic Diagram
10.1 Electrical Schematic (next page)