Snorkel SL26 Plus-sn51000 - Manual (Page 17)

Page 13 Operation Manual
PREPARATION FOR SHIPMENT
1. Fully lower the platform.
2. Turn batteries off with master switch.
3. Band the controller to the front guardrail.
LIFTING BY CRANE
1. Secure straps to chassis tie down/lifting lugs only.
2. Place the platform onto the transport vehicle in transport position.
3. Chock the wheels.
4. Secure the work platform to the transport vehicle with chains or straps of adequate load capacity attached to
the chassis tie down/lifting lugs.
Figure 5: Transporting the Work Platform
DRIVING OR WINCHING ONTO A TRUCK OR TRAILER
NOTE: Do not winch faster than 0,3 m/s (1 ft/s).
1. Move the machine onto the truck or trailer;
A. To Drive the machine onto the transport vehicle:
a. Move the work platform up the ramp and into
transport position.
b. Set the wheels straight and turn off the machine.
c. Chock the wheels.
B. To Winch the machine onto the transport vehicle:
a. Move the work platform up to the ramp.
b. Attach the winch cable to the tie down/lifting lugs.
c. Release the parking brakes (refer to “Towing or
Winching” on page 12).
d. Winch the platform into transport position
e. Chock the wheels.
2. Secure the work platform to the transport vehicle with
chains or straps of adequate load capacity attached to the chassis tie down/lifting lugs.
C A U T I O N
Overtightening of the chains or straps attached to the Tie Down/Lifting Lugs may result in damage to work
platform.
Transporting the Work Platform
TRANSPOR TING THE WORK PLATFORM
Front Tie Down
and Lifting
Lugs
Rear Tie Down/Lift