Snorkel U Drive 25-sn1125+ - Manual (Page 2)

2
3. Plug connector from rear wheels into connector
from chassis wiring.
Wheel Installation
1. After outriggers have been installed, turn
screwjacks clockwise until wheels can be
installed.
2. Install rear wheels into rear outriggers. Pin
wheels in place using pins provided.
Figure 2: Installing wheels
Outrigger Installation
1. Remove the outriggers from storage locations
on sides of mast.
2. Insert into outrigger socket in base (Figure 1).
3. Push in until locking pin engages hole in end of
outrigger. Pull outward on outrigger to ensure
engagement.
4. Repeat the above steps for all other outriggers.
Make sure all four (4) locking pins are engaged.
5. Level the base, centering the bubble in the orbit
level on the base by adjusting the screwjacks at
the end of each outrigger (Figure 1). DO NOT
release the tension on an outrigger, by turning
counterclockwise, to level base.
IMPORTANT: All four (4) screwjack pads must be
in solid contact with a firm surface and each
outrigger indicator light must be lit before the
platform is elevated.
Figure 1: Installing outriggers
Indicator Light
Level Sensor
Locking Pin
Screwjack
Figure 3: Connecting rear wheel cables
Wheel
connecting
pins
Base
Connector
Rear
Wheel
Connector
Level
Sensor
Outrigger
Lock Pin