Snorkel EPV16J - Manual (Page 35)

Chapter 7. Pre-operational Inspection
At the start of each work day (or 8 hour shift), an
EPV16J qual i fied op er a tor must per form the
Pre-op er a tional In spec tion as listed in the ta ble be -
low.
The pur pose of the Pre-op er a tional In spec tion is to
keep the EPV16J in proper work ing con di tion and
to de tect signs of mal func tion at the ear li est pos si -
ble time.
The EPV16J should be in the STOWED POSITION
and the Mas ter Key Switch set to OFF be fore you
be gin this in spec tion.
De fec tive parts and/or equip ment mal func tions
jeop ar dize the safety of the op er a tor and other per -
son nel, and can cause dam age to the ma chine.
DO NOT operate an EPV16J that is known to
be damaged or malfunctioning.
R e p a i r a l l e q u i p m e n t d a m a g e o r
malfunctions, before placing the EPV16J
into service.
EPV16J – 11089A page 7 - 1
Item Service Required
Engine fuel level Look to see that the fuel tank is full
Fuel tank cap Check to see that the cap is tight
Engine oil level Check oil level (between dipstick lines)
Fuel leaks Visually inspect (hoses and connections)
Engine coolant Check that grills are not blocked
Wiring harnesses Visually inspect (installation, condition)
Battery terminals Visually inspect (no corrosion)
Battery fluid level Check fluid level (1/4" or 6 mm below filler neck)
Hydraulic oil level Visually inspect level (between lines on gauge)
Hydraulic oil leaks Visually inspect (hoses, tubes)
Bolts and fasteners Visually inspect (condition)
Structural damage and welds Visually inspect (weld cracks, dents)
Lanyard anchor points Visually inspect (condition)
Platform gravity gate Check condition and operation
Platform guardrails Visually inspect (condition)
Flashing light (option) Visually inspect (operation)
Ground control switches Actuate and inspect for proper operation
Emergency lower Check operation (causes correct motion)
Platform control box switches Actuate and inspect for proper operation
RCD/ELCB AC outlet (option) Check operation
Platform work lights (option) Check operation
Placards and decals Visually inspect (installation, condition)
■ Pre-operational Inspection Table
DANGER