Document Outline

• Table of Contents
  • Chapter 1. Introduction
    • Safety Alerts 1-1
    • Notes 1-1
    • Options 1-1
    • Operation 1-1
    • Maintenance 1-2
    • Manual of Responsibilities 1-2
    • Additional Information 1-2
  • Chapter 2. Specifications
    • Component Identification 2-1
    • General Specifications 2-2
  • Chapter 3. Safety
    • Electrocution Hazards 3-1
      • Minimum Safe Approach Distance 3-1
    • Prestart Inspection 3-2
    • Work Place Inspection and Practices 3-2
    • Operation 3-2
    • Tip-Over and Falling Hazards 3-3
    • Electrical System 3-3
    • Hydraulic System 3-3
    • Placards and Decals 3-3
  • Chapter 4. Safety Devices
    • Emergency Stop Controls 4-1
    • Drive Motion Alarm 4-1
    • Lowering Alarm 4-1
    • Pothole Protector Skids 4-2
    • Drive/Lift Pothole Protector Interlock 4-2
    • Drive/Lift Level Sensor Interlock 4-2
    • Guardrails 4-2
    • Emergency Lowering Handle 4-3
    • Safety Prop 4-3
    • Flashing Light 4-4
    • Lanyard Anchors 4-4
    • Horn 4-4
    • Electrical Power Outlet 4-4
  • Chapter 5. Gauges
    • Hour Meter 5-1
    • Ammeter 5-1
    • Battery Condition Indicator 5-1
  • Chapter 6. Batteries
    • General Maintenance 6-1
    • Charging 6-1
  • Chapter 7. Controls
    • Lower Controls 7-1
      • Battery Disconnect Switch 7-1
      • Emergency Stop Switch 7-1
      • Control Selector Switch 7-1
      • Platform Raise/Lower Switch 7-1
      • Circuit Breaker Reset Button 7-1
      • Low Voltage Warning Light 7-1
    • Upper Controls 7-2
      • Emergency Stop Button 7-2
      • Drive/Lift Selector Switch 7-2
      • Joystick 7-2
        • Interlock 7-2
        • Steer Switch 7-2
      • Low Voltage Warning Light 7-3
      • Horn Button 7-3
      • Battery Condition Indicator 7-3
  • Chapter 8. Prestart Inspection
    • Operator™s Manual 8-2
    • Electrical System 8-2
      • Battery Fluid Level 8-2
      • Battery Terminals 8-2
      • Battery Charger 8-2
      • Cables and Wiring Harness 8-3
    • Hydraulic System 8-3
      • Fluid Level 8-3
      • Hoses, Tubes, and Fittings 8-3
      • Free-Wheeling Valve 8-4
    • Tires and Wheels 8-4
      • Parking Brakes 8-4
    • Ground Strap 8-4
    • Lower Control Station 8-4
      • Operating Controls 8-4
      • Emergency Stop 8-5
      • Lowering Alarm 8-5
    • Pothole Protector Interlock 8-5
    • Level Sensor Interlock 8-6
    • Emergency Lowering 8-6
    • Safety Prop 8-6
    • Flashing Light 8-7
    • Structures 8-7
      • Weldments 8-7
      • Rollers and Slide Blocks 8-7
      • Fasteners 8-7
    • Upper Control Station 8-8
      • Guardrail System 8-8
      • Platform Extension 8-8
      • Operating Controls 8-8
      • Emergency Stop 8-9
      • Lowering Alarm 8-9
      • Drive Motion Alarm 8-9
      • Battery Condition Indicator 8-9
      • Lanyard Anchors 8-9
      • Horn 8-9
      • Electrical Power Outlet 8-9
    • Placards and Decals 8-10
  • Chapter 9. Operation
    • Preparing for Operation 9-1
    • Lower Controls 9-1
    • Upper Controls 9-1
      • Driving 9-2
        • Drive Speeds 9-2
        • Drive/Lift Level Sensor Interlock 9-2
      • Steering 9-2
      • Platform 9-3
        • Raising and Lowering 9-3
        • Extending 9-3
    • Brakes 9-3
    • Swing-Out Trays 9-4
    • Electrical Power Outlet 9-4
  • Chapter 10. Stowing and Transporting
    • Stowing 10-1
    • Transporting 10-1
      • Winching 10-1
      • Driving 10-2
      • Hoisting 10-2
      • Lifting With a Forklift 10-2
      • Securing for Transport 10-3
  • Chapter 11. Emergency Operation
    • Emergency Lowering 11-1
    • Towing 11-1
  • Chapter 12. Troubleshooting
    • Troubleshooting Chart 12-1
  • Appendix A. Glossary
• Index
  • A
    • AC generator, 1-1
    • aerial platform drive and speed, 7-2
    • aerial platform stability, 8-4
    • aerial platform steering, 7-2
    • American National Standards Institute (ANSI), 1-1
    • ammeter, 5-1, 6-1
  • B
    • batteries, 8-2
    • battery charger, 6-1
    • battery condition indicator, 1-1, 5-1, 7-3, 8-9, 9-1
    • battery disconnect switch, 7-1, 9-1
    • battery fluid level, 8-2
    • battery terminals, 8-2
      • cable ends, 8-2
    • brakes, 9-3
      • brake disc, 9-3
      • brake pin, 9-3
      • disengaging, 9-4
      • release cam, 8-4
  • C
    • cables and wiring harness, 8-3
    • Canadian Standards Association (CSA), 1-1
    • circuit breaker reset button, 7-1, 9-1
    • component identification, 2-1
    • control selector switch, 7-1, 9-1
  • D
    • DC electrical motor, 8-3
    • drive motion alarm, 4-1, 8-9
    • drive speeds, 9-2
    • drive/lift level sensor interlock, 4-2, 9-2
    • drive/lift pothole protector interlock, 4-2
    • drive/lift selector switch, 7-2, 9-1
    • driving, 9-2, 10-2
  • E
    • electrical overload, 7-1
    • electrical power, 1-1
    • electrical power outlet, 4-4, 8-9, 9-4
      • power-input connector, 9-4
    • electrical system, 2-2, 3-3, 8-2
    • electrocution hazards, 3-1
    • emergency lowering, 8-6, 11-1
      • lowering handle, 4-3, 8-6, 11-1
    • emergency stop, 7-1, 8-9
      • button, 7-2
      • controls, 4-1
      • switch, 7-1, 8-5
    • entering or exiting the platform, 3-2
  • F
    • fasteners, 8-7
    • flashing light, 1-1, 4-4, 8-7
    • free-wheeling valve, 8-4, 11-1
      • closing, 8-4
  • G
    • general maintenance, 6-1
    • general specifications, 2-2
    • gradeability, 2-2
      • 25 percent grade, 9-2
    • ground clearance, 2-2, 4-2, 8-5
    • ground fault circuit interrupter, 8-9
      • reset button, 8-9
      • test button, 8-9
    • ground strap, 8-4
    • guardrail system, 8-8
      • guardrails, 4-2
      • mid rail, 8-8
      • removable top rail, 8-8
      • safety chain, 8-8
      • swinging gate, 8-8
      • toeboards, 8-8
      • top rail, 8-8
  • H
    • hoisting, 10-2
    • horn, 1-1, 4-4, 8-9
      • button, 7-3, 9-1
    • hoses, tubes, and fittings, 8-3
      • routing, 8-3
    • hour meter, 5-1
    • hydraulic system, 3-3, 8-3
      • fluid level, 8-3
      • fluid recommended, 2-2
      • hydraulic pump, 8-3
  • I
    • inspection, 1-2
    • interlock, 8-8, 9-2
  • J
    • joystick
      • lift and steer, 7-2, 9-1
  • L
    • lanyard anchors, 1-1, 4-4, 8-9
    • level ground, 3-3
    • level sensor interlock, 8-6
    • lifting with a forklift, 10-2
    • loss of hydraulic power, 11-1
    • low voltage warning light, 7-1, 7-2, 7-3, 9-1
    • lower control station, 8-4
    • lower controls, 4-1, 7-1, 9-1
    • lowering alarm, 4-1, 8-5, 8-9
  • M
    • maintenance, 1-2
    • manual of responsibilities, 1-2
    • minimum safe approach distance, 3-1
  • O
    • Occupational Safety and Health Administration (OSHA), 1-1
    • operation, 3-2
    • operator™s manual, 8-2
      • manual holder, 8-2
    • options, 1-1
    • overall height, stowed, 2-2
    • overall length, stowed, 2-2
    • overall width, 2-2
  • P
    • parking brakes, 8-4
    • placards and decals, 3-3, 8-10
      • cleaning, 3-3
      • Snorkel part number, 8-10
    • platform, 9-3
      • raising and lowering, 9-3
    • platform capacity, 3-3
    • platform extend trigger, 9-3
    • platform extension, 8-8
    • platform raise/lower and speed, 7-2
    • platform raise/lower switch, 7-1, 9-1
    • positioning safety prop, 4-3
    • pothole protector
      • interlock, 8-5
      • interlock test, 8-5
      • skids, 4-2
    • preparing for operation, 9-1, 9-2
    • prestart inspection, 3-2
    • prestart inspection table, 8-1
  • R
    • rated work load, 9-3
    • reservoir, 8-3
      • capacity, 2-2
      • fluid level, 8-3
      • level indicator, 8-3
  • S
    • safety alerts, 1-1
    • safety prop, 4-3
    • scissors arm rollers, 8-7
    • securing for transport, 10-3
    • slide blocks, 8-7
    • steering, 9-2
    • stowing safety prop, 4-3
    • stowing work platform, 10-1
    • structures, 8-7
      • mechanical, 8-7
      • weldments, 8-7
    • swinging gate, 1-1, 4-2
    • swing-out tray, 8-2, 9-4
      • latch keeper, 9-4
  • T
    • tie-down lugs, 10-2
    • tip-over and falling hazards, 3-3
    • tires, 2-2
    • toeboard height, 2-2
    • towing, 11-1
    • training, 1-1
    • transporting work platform, 10-1
    • turning radius, 2-2
  • U
    • upper control station, 8-8
    • upper controls, 4-1, 7-2, 9-1
  • W
    • wheel lug nuts, 8-4
    • winching work platform, 10-1
    • windy or gusty conditions, 3-3
    • work place inspection and practices, 3-2
    • working height, 2-2