Aries Automotive 1042 - Manual

ARIES OFFROAD
1042 GRAND CHEROKEE
1995-1998 4WD
INSTALLATION INSTRUCTIONS
PARTS LIST
1 – Aries Front Bar
1 – Mounting Bracket – Driver Side
1 – Mounting Bracket – Passenger Side
6 – 3/8’’ x 1
1/4’’ Hex Bolts
12 – 3/8’’ USS Flat Washers
6 – 3/8’’ Nylon Lock Nuts
INSTALLING THE MOUNTING BRACKETS
Remove factory tow hooks from front section of vehicle (located within front bumper area).
Using the bolts that held the tow hooks in place (there should be two of these bolts per hook). Attach
the mounting brackets as per diagram below , do not fasten these bolts too tightly as you may have to
move the brackets around slightly to align the grill guard to your vehicles front bumper – see next step
installing the grill guard.
INSTALLING THE FRONT BAR
Line up the three holes on the lower portion of the front bar with the three holes in the mounting
brackets (outer edge). Use the 3/8’’ hex bolts and the 3/8’’ lock nuts to fasten guard to the mounting
brackets. Once the guard is attached to the brackets align guard to the bumper. Ounce you are
satisfied that the grill guard is aligned.
Begin to tighten all fasteners.
DIAGRAM. DRIVERS SIDE SHOWN