Aries Automotive P5056 - Manual (Page 2)

3. With the LED light attached to the support flange select the (2) 8mm nut clips place each nut
clip into the slotted holes on either side of the support flange, as seen in (Fig 2) with the
support flange prepare you will need to lay the grill guard face down to install the support
flange NOTE: (it is recommended to lay out some of the cardboard your grill guard came in or
a blanket to protect the grill guard finish). place the grill guard face down with this done place
the support flange with the LED attached into the Center flange attach each side of the support
flange to the inner brackets inside the center flange of the grill guard with (2) 8mm hex bolts,
(2) 8mm flat washers, & (2) 8mm lock washers as seen in (Fig 3) Snug but do not tighten at
this time.
4. Next proceed with your install by removing the factory tow hook of the vehicle Passenger side
(Note: tow hook will not be reattached), attach the mounting bracket in place of the tow hook
and secure the mount bracket with the supplied (4) 10mm x 60mm hex bolt, (8) 10mm flat
washers (4) 10mm lock washers (4) 10mm nut (Fig 4) shows mount bracket attached. Snug
but do not tighten hardware at this time. Repeat this step for the driver/Left side installation.
5. With help begin to install Grille Guard, move the Passenger/Right side and Driver/Left side
Mounting Brackets in as far as possible, and (loosen hardware slightly if necessary). Position
the Grille Guard up to the Outer side of the Passenger/Right side Mounting Bracket and line up
the mounting holes in the Mounting Bracket with the holes in the Grille Guard, bolt together
with the included (3) 12mm x 30mm Hex bolts (6) 12mm flat Washer, (3) 12mm lock washers
and (3) 12mm Hex Nut, Repeat this step for the Driver/left side. (Fig 5) shows grill guard
attached to mount brackets, Snug but do not tighten hardware at this time.
6. Adjust the Grille Guard as required for alignment. Tighten all mounting hardware, your install of
the grill guard is now completed.
7. For the Led lights wiring please refer to the manufactures installation.
8. Do periodic inspections to the installation to make sure all hardware is secure and tight.
To protect your investment, wax this product after installing. Regular waxing is recommended to
add a protective layer over the finish. Do not use any type of polish or wax that may contain abrasives
that could damage the finish.
Fig 1
LED light attached to support flange.
NOTE:
LED Manufactures will have similar
but different mounting styles or brackets,
once you determine you mounting options
attach it to the support flange as seen.
Page 2 of 3 10/29/2013