Aries Automotive B35-3012 - Manual (Page 2)

Page 2 of 2 6/18/10 (DP)
Installation Complete
For stainless steel: Aluminum polish may be used to polish small scratches and scuffs on the finish.
Mild soap may be used also to clean the Bull Bar.
For gloss black finishes: Mild soap may be used to clean the Bull Bar.
Driver Side Installation Pictured
Remove these
(2) factory hex bolts
10mm x 30mm Hex Bolts
10mm Flat Washers
10mm Nylon Lock Nuts
Fig 1
WARNING! Do not loosen or remove
passenger and driver side bumper mounting
bolts at the same time or bumper will move out
of alignment or may fall off of the vehicle. Only
remove the bumper bolts from one side and
install one Mounting Bracket at a time.