Aries Automotive B35-2006 - Manual

Page 1 of 3 4/23/10 (DP)
PARTS LIST:
1 Bull Bar
1 Driver/Left Frame Mounting Bracket
1 Passenger/Right Frame Mounting Bracket
4 12-1.75mm x 30mm Hex Head Bolts
8 12mm ID x 24mm OD x 2.5mm Flat Washers
4 12mm Lock Washers
4 12mm Hex Nuts
PROCEDURE:
1. REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ INSTRUCTIONS
CAREFULLY BEFORE STARTING INSTALLATION. CUTTING REQUIRED
2. From under the front of the vehicle, remove the driver side and passenger side plastic splash guards
and place them on a clean, stable work area, (Figure 1). To make reinstallation easier, note type and
location of all factory fasteners. The plastic center splash guard may also be removed for better access
to hardware if necessary. IMPORTANT: Apply masking tape to the openings in the bumper to protect
the painted finish during bracket installation.
3. Starting on the driver side, remove the (3) factory bumper mount bolts located toward the outside of the
bumper mount. Select the driver side frame mounting bracket and insert it into the opening in the back
of the bumper cover (Figure 2). Line up the (3) slots in the Mounting Bracket with the (3) bolt locations
for the factory bumper bracket, (Figure 2). Secure the Frame Mounting Bracket to the factory bumper
bracket using the (3) factory bolts removed earlier. Snug but do not tighten hardware at this time.
Repeat this Step for passenger side Frame Mounting Bracket installation.
4. With assistance, line up the mounting tabs on the Bull Bar with the (2) previously installed Frame
Mounting Brackets. Bolt the Bull Bar to the Frame Mounting Brackets with the included (4) 12mm x
30mm Hex Bolts, (8) 12mm Flat Washers, (4) 12mm Lock Washers and (4) 12mm Hex Nuts, (Figure 3
& 4). Snug but do not tighten hardware at this time.
5. Level and adjust Bull Bar properly and tighten all hardware. Reinstall the center splash guard if it was
previously removed.
Driver Side
Mounting
Bracket Passenger
Side Mounting
Bracket
Complete Installation
INSTALLATION INSTRUCTIONS
3 INCH BULL BAR PART #35-2006/B35-2006
2010 TOYOTA 4-RUNNER