Aries Automotive B35-2009 - Manual (Page 3)

BULL BAR
2014 TOYOTA HIGHLANDER
Page 2 of 4 8/6/14 (DP)
knife or hacksaw blade to cut out the traced area for the Mounting Brackets. IMPORTANT: To maintain
strength in the splash guard, only remove necessary material to clear the Mounting Brackets. Next, use
a 1/2" drill bit or a sharp knife to open a hole for the threaded end of the (2) Bolt Plates to go through as
described in Step 4.
10. Temporarily re-install the splash guard using the factory hardware. Check the fit of the Support
Brackets and the ends of the Bull Bar and trim the splash guard as required. Once properly fit, fully
install the splash guard.
11. Reinstall the Support Brackets over the splash guard.
12. Reinstall the Bull Bar.
13. Do periodic inspections to the installation to make sure that all hardware is secure and tight.
To protect your investment, wax this product after installing. Regular waxing is recommended to add a protective layer
over the finish. Do not use any type of polish or wax that may contain abrasives that could damage the finish.
For stainless steel: Aluminum polish may be used to polish small scratches and scuffs on the finish. Mild soap may be
used also to clean the Bull Bar.
For gloss black finishes: Mild soap may be used to clean the Bull Bar.
Passenger Side Installation Pictured
Remove plastic plugs on top
and bottom of cross member
(Fig 1) Remove plastic splash guard
(Fig 2) Passenger side mounting location (arrows)
Fig 3
Front
Front
Front
Crossmember