Aries Automotive TB45-5005 - Manual (Page 4)

Page 4 of 5
Driver Side Installation Pictured
Fig 4
Fig 5
Hold the splash guard up to the brackets
and mark location for cutting to clear
brackets. Cut only what is needed to
insert bracket through the splash guard.
Measure from the mounting point
for the splash guard to the
bracket on the driver and
passenger sides. Use this
measurement as a reference point
to check location before cutting
the 1/2" wide x 4" long slot
Fig 3
IMPORTANT: On trucks without tow
hooks, use only the supplied
12-1.5mm x 30mm Fine Thread Hex Bolt
12mm Flat Washer
12mm Lock Washer
Hole for mounting bolt
Installation pictured
without the splash
guard for illustration
Cut only what is needed to insert bracket
through the splash guard. Do not cut
through the front edge of the splash guard
Upper Frame Mounting
Bracket installation
Lower Frame Mounting
Bracket installation
Fig 6