Aries Automotive 205019-2 - Manual (Page 3)

Page 3 of 4 1/20/2010
10. Level and align Sidebar properly; then tighten all hardware at this time.
11. Repeat steps 2-7 for driver Sidebar.
12. Do periodic inspections to the installation to make sure all hardware is secure and tight.
To protect your investment, wax this product after installing. Regular waxing is recommended to
add a protective layer over the finish. Do not use any type of polish or wax that may contain abrasives
that could damage the finish.
For stainless steel: Aluminum polish may be used to polish small scratches and scuffs on the finish.
Mild soap may be used also to clean the Sidebar.
For gloss black finishes: Mild soap may be used to clean the Sidebar.
PASSENGER SIDE INSTALLATION PICTURED
Fig 1 Fig 1A
Remove factory
Body Bolt & washer
(not reused)
Install mounting bracket with
(1)12mm x 120mm Hex bolt
(1)12mm x 44OD flat washer
(1)12mm lock washer
Fig 2
Fig 2A
Tee Bolt Plate
installed into lower
front frame rail
Secure to Tee bolt plate
(1)10mm flat washer
(1)10mm lock washer
(1)10mm Nut
Secure to sidebar
(1) 10mm x 35mm hex bolt
(1) 10mm flat washer
(1) 10mm lock washer
(1) 10mm Nut