Aries Automotive W15500-2 - Manual

INSTALLATION INSTRUCTIONS
DOUBLE TUBE FRONT BUMPER WITHOUT / WITH WINCH MOUNT
PART# 15500/15500-2/W15500/W15500-2
07 JEEP WRANGLER 4 DOOR
PARTS LIST
1 Front
Bumper
2 Brackets
8
12MM X 35MM bolts
8 12MM nylon lock nuts
16 12MM washers
PROCEDURE:
1. REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ
INSTRUCTIONS CAREFULLY.
2. Unplug the bumper lights electrical connections (Fig 1)
3. Remove front factory bumper by removing the eight mounting bolts with a 17MM
socket wrench (Fig 1)
4. Install the new bumper brackets as shown in photos. Note that the bracket faces
rearward and the forward facing holes (those the mounts bolt onto the frame) are
horizontal, and those the bumper mounts to are vertical. (Fig 2)
5. Install the 12MM bolts and locking nuts to the mounts but leave finger tight to allow for
adjustment
6. Install the 12MM bolts and locking nuts to the bumper and the mount.
7. Adjust the bumper and tighten all the bolts. (Fig 3)
Fig 2 Note the orientation of the bolt holes
Fig 1
Fig 3
Bumper light plug
Four mounting bolts
per side