Aries Automotive 15501-2 - Manual

INSTALLATION INSTRUCTIONS
REAR BUMPER WITH DOUBLE TUBE
PART#15501/15501-2
07 JEEP WRANGLER 4 DOOR
PARTS LIST
1 Bumper
2
Brackets
2 Bolt plates
10 12MM X 35MM bolts
12 12MM washers
6 12MM lock nuts
4 12MM lock washers
PROCEDURE:
1. REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ
INSTRUCTIONS CAREFULLY.
2. Locate, remove and set aside the brackets (Fig 1)
3. Remove factory bumper by removing the side brackets (Fig 2) and the bolts in the removable
brackets (Fig 3)
4. Insert the driver side bracket into the frame (Fig 3)
5. Start the two 12MM bolts and thick washers through the bolt plate and into the frame.
6. Repeat the bracket installation on the passenger side of the vehicle.
7. Insert a thin piece of wood between the bumper and the trailer hitch receiver to prevent
damage. (Fig 4)
8. Position the bumper in between the two mounts and start the six 12MM bolts, washers and
locking nuts. (Fig 5)
9. Level the bumper and tighten all the fasteners. (Fig 6)
Fig 1
Driver side bracket
Passenger side bracket Factory bumper bracket
Fig 2