Advance Adapters 50-9002 - Manual (Page 3)

ADVANCE ADAPTERS INC. P/N: 50-9002
P.O. Box 247, 4320 Aerotech Center Way New Item: (9/09)
Paso Robles, CA 93447 PAGE
Telephone: (800) 350-2223 Fax: (805) 238-4201 Page Rev. Date:
SPECIAL NOTE: The components packaged in this kit have been assembled and machined for specific type of conversions. Modifications to any of the components will
void any possible warranty or return privileges. If you do not fully understand modifications or changes that will be required to complete your conversion, we strongly recommend
that you contact our sales department for more information. This instruction sheet is only to be used for the assembly of Advance Adapter components. We recommend that a
service manual pertaining to your vehicle be obtained for specific torque values, wiring diagrams and other related equipment. These manuals are normally available at automotive
dealerships and parts stores.
3 OF 6
LAND ROVER SERIES T-CASE to NP
CIRCULAR 6 ADAPTER with GM 10 SPLINE
2. Apply a 1/8" bead of high quality silicone on the transfer case
mounting surface, Insure that you encircle the idler pin bore and the
perimeter of the casting.
3. Install the dowel pins into the adapter casting (these are a slip fit, so
be careful not to lose them)
4. Install the assembled adapter plate to the transfer case.
Use locking compound on all of the interior bolts and lock
washers to insure they do not back out in use. Torque 3/8"
bolts to 35 ft.lbs.
5. Install the remaining 3/8" bolts and lock washers. Torque
to 35ft.lbs. Also install the two 5/16" bolts assemblies to the top of the adapter.
6. Install the new breather elbow into the adapter with sealant on thread.
03-25-10