Advance Adapters 303020A - Manual (Page 7)

Link bar installation: The link bar provides the option of moving the shifter cable connection point on the Atlas
shift rail. Some transmissions are extremely tight on the tailhousing clearance to the rear output shifter rail of the
Atlas. This block allow an off set of .500". The installation on the cable is basically the same as mentioned in the
assembly instructions, with just a few exceptions. One each of the nut cap and cable nuts will not be used.
The front mount in the shifter kit has been machined
for clearance on the link bar, and the 303307 cable
support needs to be mounted like the photo shown.
The cable is installed into the upper hole.
The link bar
consist of 3 parts
and should be
come as-
sembled.
The link bar
should be
installed on the
cable. Install so
that approx. 1/4"
of threads are
past the brass
nut (see photo).
This cable length should match the other cable on the front
output. Thread the brass nut onto the shift rail and then follow the
adjustment procedures on page 3 & 4.
ADVANCE ADAPTERS INC. P/N: 303020A
P.O. Box 247, 4320 Aerotech Center Way New Item: (2/08)
Paso Robles, CA 93447 PAGE 7 OF 9
Telephone: (800) 350-2223 Fax: (805) 238-4201 Page Rev. Date: 04-24-12
***NOTE: Due to slight variations in the stock floor, the shifter box mounting holes may require enlarging
to get everything aligned correctly.
11. If test shifting was successful, install one shift knob mounts onto the passenger handle and secure using
the 1/4"-28 x 3/4" flat head cap screws
and then reinstall the center console.
12. Install the second shift knob
mount followed by the two 3/
8"-16 x 1.5" shift knob studs
(ALLEN END DOWN).
13. The aluminum shift knobs can
be adjusted by tightening or
loosening the studs with an
allen wrench from the access
hole.
NOTE: Butyl tape applied to flange
Shifter Box
303330
ATLAS T/C JEEP TJ & (XJ 84-01)
CABLE SHIFTER