Advance Adapters 7155730 - Manual (Page 2)

715575
715577
715581
715585
715576
715579
FJ4404
(4 PLCS.)
715587A
7155876A
715588
715584
715583
715582
715580
(2 PLCS.)
ADVANCE ADAPTERS INC. P/N: 715573
P.O. Box 247, 4320 Aerotech Center Way New Item: (8/02)
Paso Robles, CA 93447 PAGE 2 OF 5
Telephone: (800) 350-2223 Fax: (805) 238-4201 Page Rev. Date: 10-04-06
SPECIAL NOTE: The components packaged in this kit have been assembled and machined for specific type of conversions. Modifications to any of the components will
void any possible warranty or return privileges. If you do not fully understand modifications or changes that will be required to complete your conversion, we strongly recommend
that you contact our sales department for more information. This instruction sheet is only to be used for the assembly of Advance Adapter components. We recommend that a
service manual pertaining to your vehicle be obtained for specific torque values, wiring diagrams and other related equipment. These manuals are normally available at automotive
dealerships and parts stores.
TOYOTA L/C TRANSFER CASE TWIN STICK
shift fork bolt
detent ball and spring
INSTALLATION OF PART #715585:
This kit requires the installation of a new mode selector shaft into your stock
transfer case. This shaft can be installed with the transfer case still in the vehicle.
The mode shaft is installed into an aluminum housing that is bolted to the front
output shaft housing of the transfer case. This mode shaft housing bolts on using
(4) 12mm bolts. By removing these bolts, the mode housing can be removed from
the transfer case. Set the mode housing on a bench and remove the plug bolt to
expose the bolt that couples the shift fork to the mode shaft. Remove the shift fork
bolt through this access hole. Remove the
shifter detent ball and spring by removing the
detent bolt. Remove the rubber boot from the
mode housing and pull the mode shaft from the housing. Install the new mode shaft
through the seal and into the housing with the detent notches in the correct orientation.
Reinstall the shift fork bolt into the shift fork and new mode shaft. Insert the detent
ball, spring and cap into the housing. Slide the rubber boot back onto the mode shaft.
Install the mode housing back onto the transfer case, making sure to silicone between
the surfaces to secure for no leaks.