IKA RW 20 digital - Manual (Page 10)

RW20d0506 10
Page
CE - Declaration of conformity 2
Safety instructions 10
Correct use 11
Unpacking 11
Motor protection 11
Gear speed change 12
Speed display 12
Commissioning 12
Attaching - stirrer 12
- stirrer tools
- stirrer shaft protection device
Switching on the device 13
Output shaft 13
Maintenance 13
Warranty 14
Accessories 14
Permitted IKA stirrer tools 14
Technical data 15
• Read the operating instructions in full before starting up
and follow the safety instructions.
• Keep the operating instructions in a place where they can be
accessed by everyone.
• Ensure that only trained staff work with the appliance.
• Follow the safety instructions, guidelines, occupational health
and safety and accident prevention regulations.
• The voltage stated on the nameplate must correspond to the
mains voltage.
• Socket must be earthed (protective ground contact).
• Wear your personal protective equipment in accordance with the
hazard category of the medium to be processed. Otherwise
here is a risk of:
- splashing liquids
- projectile parts
- body parts, hair, clothing and jewellery getting caught.
• Set up the appliance in a spacious area on an even, stable, clean,
non-slip, dry and fireproof surface.
• The feet of the appliance must be clean and undamaged.
• Position the knob (B) at the left stop before starting up. Gradually
increase the speed.
• Reduce the speed if
- the medium splashes out of the vessel because the speed is
too high
- the appliance is not running smoothly
- the appliance begins to move around because of dynamic forces.
• Firmly secure the accessories and vessels in place, otherwise
shaking vessels could be damaged or projected out.
• Check the appliance and accessories beforehand for damage
each time you use them. Do not use damaged components.
• The equipment is not suitable for manual operation.
• Beware of the risk of
- flammable materials
- glass braekage as a result of mechanical shaking power
• There may be dangerous electrostatic activity between the
medium and the output shaft
• Only process media that will not react dangerously to the
extra energy produced through processing. This also applies
to any extra energie produced in other ways, e.g. through ligh
irradiation.
• Do not operate the appliance in explosive atmospheres,
with hazardous substances or under water.
• Safe operation is only guaranteed with the accessories desci
bed in the “Accessories” chapter.
• Always disconnect the plug before fitting accessories.
• The appliance starts up again automatcally following a cut in
the power supply.
Contents
Safety instructions
EN