Brother LX-910D - Manual (Page 10)

- 8 -
Control Panel
POWER SWITCH On/Off Turns the machine on/off.
(cut button) Cuts the document in the current position.
Feed Use to feed the document manually.
Start/Stop Use this button to start or stop an operation.
The green LED indicates that the machine has power, and is
turned on.
Auto Cut Mode selector switch
- Border
The machine will cut the film with about a 0.18” (4.5mm) margin
from each edge of the document.
- Leaves an extra margin of laminate.
- No Border The machine will cut the film with a margin that is approximately
0.06” (1.5mm) from each edge of the document.
- Trims the laminate close to the document.
-Off Turns the cutting mode off.
Power switch
Cut button
Feed button
Start/Stop button
Auto Cut Mode
Selector switch
Cutting line
Film slit
Shutter button
Shutter
Plastic side holder
Projection
Film Cartridge
Cutting line Cuts the excess film on this line to install the cartridge properly.
Shutter Lifts the shutter upward to open the film cartridge cover.
Shutter button Locks the film cartridge cover and returns the shutter to original
position.
Film slit The top edge of film appears from this film slit.
Optional Film Refills