Brother CS 80 - Manual (Page 31)

Upper Threading 25
1
4
Thread the thread cassette with the thread
from the spool on the extra spool pin.
• For more details, refer to “ Loading the spool
into the thread cassette” (page 19).
5
Insert the thread cassette (with the extra spool
pin attached) into the thread cassette
compartment.
Use both hands to press down on both sides of
the extra spool pin.
X At the same time that the thread cassette is
inserted, the needle is threaded.
X The extra spool pin is now installed.
Thread the needle manually
(without using the needle threader)
When using special thread, thread with a thickness
of 130/20 or less, the wing needle or the twin needle
which cannot be used with the needle threader,
thread the needle as described below.
1
Remove the needle.
• Refer to “ Replacing the needle” (page 32).
• When using the wing needle, the twin
needle or thread that cannot be used with
the needle threader, be sure to remove the
needle, otherwise the machine may be
damaged.
2
Check that the thread cassette indicator is lit
up in green, and then insert the thread cassette
into the thread cassette compartment.
• For details, refer to
1
through
2
(page 22).
X Pass the thread through the needle bar
thread hook.
1 Needle bar thread hook
3
Install a needle.
• Refer to “ Replacing the needle” (page 32).
4
Pass the thread through the eye of the needle
from front to back.
1
S2_brotherE.book Page 25 Thursday, February 13, 2003 11:03 AM