JLG 860SJ Operator Manual - Manual (Page 39)

SECTION 3 - MACHINE CONTROLS AND INDICATORS
3121138 – JLG Lift – 3-1
SECTION 3. MACHINE CONTROLS AND INDICATORS
3.1 GENERAL
THE MANUFACTURER HAS NO DIRECT CONTROL OVER MACHINE
APPLICATION AND OPERATION. THE USER AND OPERATOR ARE
RESPONSIBLE FOR CONFORMING WITH GOOD SAFETY PRACTICES.
This section provides the necessary information needed to
understand control functions.
3.2 CONTROLS AND INDICATORS
NOTE: This machines is equipped with control panels that use
symbols to indicate control functions. Refer to decal
located on the control box guard in front of the control
box or by the ground controls for these symbols and the
corresponding functions.
Ground Control Station
(See Figure 3-1., Ground Control Station - 800S and Figure 3-1.,
Ground Control Station - 860SJ)
NOTE: When Power/Emergency Stop switch is in the “ON” posi-
tion and engine is not running, an alarm will sound, indi-
cating Ignition is “ON”.
WHEN THE MACHINE IS SHUT DOWN THE MASTER/EMERGENCY STOP
SWITCH MUST BE POSITIONED TO THE “OFF” POSITION TO PREVENT
DRAINING THE BATTERY.
NOTE: If equipped, the Function Enable switch must
be held down in order to operate Telescope,
Swing, Lift, Jib Lift, Platform Level Override,
and Platform Rotate functions.