JLG 860SJ Operator Manual - Manual (Page 53)

SECTION 3 - MACHINE CONTROLS AND INDICATORS
3121138 – JLG Lift – 3-15
16. Drive Orientation Override
When the boom is swung over the rear tires or further in
either direction, the Drive Orientation indicator will illumi-
nate when the drive function is selected. Push and
release the switch, and within 3 seconds move the
Drive/Steer control to activate drive or steer. Before driv-
ing, locate the black/white orientation arrows on both
the chassis and the platform controls and match the
control direction arrow to the intended chassis direction.
17. Soft Touch Override Switch (If equipped)
This switch enables the functions that were cut out by
the Soft Touch system to operate again at creep speed,
allowing the operator to move the platform away from
the obstacle that caused the shutdown situation.
18. Soft Touch Indicator (If Equipped)
Indicates the Soft Touch bumper is against an object. All
controls are cut out until the override button is pushed,
at which time controls are active in the Creep Mode.
Platform Control Indicator Panel
(See Figure 3-7., Platform Light Panel - w/Drive Orientation)
NOTE: The platform control indicator panel uses different shaped
symbols to alert the operator to different types of opera-
tional situations that could arise. The meaning of those
symbols are explained below.
Indicates a potentially hazardous situation, which
if not corrected, could result in serious injury or
death. This indicator will be red.
Indicates an abnormal operating condition,
which if not corrected, may result in machine
interruption or damage. This indicator will be yel-
low.
Indicates important information regarding the
operating condition, i.e. procedures essential for
safe operation. This indicator will be green with
the exception of the capacity indicator which will
be green or yellow depending upon platform
position.