JLG 41AM Operator Manual - Manual (Page 24)

SECTION 2 - USER RESPONSIBILITIES, MACHINE PREPARATION, AND INSPECTION
2-4 – JLG Lift – 3121211
2.3 PRE-START INSPECTION
The Pre-Start Inspection should include each of the following:
1. Cleanliness – Check all surfaces for leakage (oil, fuel,
or battery fluid) or foreign objects. Report any leakage
to the proper maintenance personnel.
2. Decals and Placards – Check all for cleanliness and
legibility. Make sure none of the decals and placards
are missing. Make sure all illegible decals and placards
are cleaned or replaced.
3. Operators and Safety Manuals – Make sure a copy of
the Operator and Safety Manual, AEM Safety Manual
(ANSI Markets Only), and ANSI Manual of Responsibili-
ties (ANSI Markets Only) is enclosed in the weather
resistant storage container.
4. Walk-Around Inspection – Refer to Figure 2-1. on
page 2-7.
5. Battery – Charge as required.
6. Fuel – (Combustion Engine Powered Machines Only) –
Add proper fuel as necessary.
7. Hydraulic Oil – Check hydraulic oil level. Add hydrau-
lic oil as required.
8. Function Check – Once “Walk-Around” Inspection is
complete, perform a function check of all systems in
an area free of overhead and ground level obstruc-
tions. Refer to Section 3 for specific instructions.
IF MACHINE DOES NOT OPERATE PROPERLY, TURN OFF MACHINE IMMEDI-
ATELY! REPORT PROBLEM TO PROPER MAINTENANCE PERSONNEL. DO NOT
OPERATE MACHINE UNTIL IT IS DECLARED SAFE FOR OPERATION.