JLG 41AM Operator Manual - Manual (Page 25)

SECTION 2 - USER RESPONSIBILITIES, MACHINE PREPARATION, AND INSPECTION
3121211 – JLG Lift – 2-5
2.4 FUNCTION CHECK
The function check of all systems should be performed in an
area free of overhead and ground level obstructions. Perform a
function check as follows:
1. Set-up machine for operation according to instruc-
tions in Section 3. Install outriggers, level machine,
make sure all wheels are off the ground, etc.
2. Enter platform, raise and lower platform 2 ft to 3 ft
(.61m to .92 m) several times. Check for smooth eleva-
tion and lowering of platform.
3. With platform completely lowered, check hydraulic oil
level in reservoir at ground control station. Maintain
an oil level to "Fill to Line" indicator on side of reser-
voir. NEVER USE HYDRAULIC BRAKE FLUID.
2.5 DAILY WALK-AROUND INSPECTION
General
Begin Walk-Around Inspection at item 1 (See Figure 2-1. on
page 2-7). Continue around machine checking each item in this
check list.
CAUTION
TO AVOID POSSIBLE INJURY, BE SURE MACHINE POWER IS OFF DURING
WALK-AROUND INSPECTION.
NOTICE
DO NOT OVERLOOK VISUAL INSPECTION OF CHASSIS UNDERSIDE. CHECKING
THIS AREA MAY RESULT IN DISCOVERY OF CONDITIONS WHICH COULD CAUSE
EXTENSIVE MACHINE DAMAGE.
NOTE: On each item, make sure there are no loose or missing
parts. That they are securely fastened and that no visible
damage exists in addition to any other criteria mentioned.
1. Front Caster Wheels - Properly secured, wheels and
casters turn freely. Brakes lock and release - prevent
wheels from rolling when locked.
2. Rear Wheels - Properly secured. Wheels turn freely.
3. Tiltback Wheels - Properly secured. Wheels turn
freely.