JLG 41AM Operator Manual - Manual (Page 71)

SECTION 5 - OPTIONAL EQUIPMENT
3121211 – JLG Lift – 5-3
5.2 AM-SE - STRADDLE EXTENSION – INSTALLATION
Description
The AM-SE straddle extension increases the versatility of the AM
Series by providing a bridge for access to areas where obstacles
such as rows of seats, machines, counters or stairwells are
encountered.
The straddle extension provides clearance of up to 48 inches
(1.2m) in height and is adjustable from 104 to 128 inches (2.6m
to 3.3 m) in length.
Straddle Adaptor Wiring Components
The straddle wiring for both the AM Series includes the follow-
ing parts:
1. Two (2) short wiring harness’.
2. Two (2) Spring Clips.
3. Four (4) #10-24 x .625 long bolts, nuts and lock wash-
ers.
4. Two (2) 3/8" I.D.\ 1/2" O.D grommets.
Straddle Adaptor Wiring Installation
1. Set up machine installing outriggers, level machine
and raise the platform as high as necessary to allow
access base frame.
NEVER WORK UNDER AN ELEVATED PLATFORM UNTIL PLATFORM HAS BEEN
SAFELY RESTRAINED FROM ANY MOVEMENT BY JACK STAND OR OVERHEAD
SLING.
2. Place a floor jack or other suitable support between
the mast and floor before working underneath plat-
form.
NOTICE
ON AC MACHINES UNPLUG THE POWER CORD, DC POWERED MACHINES DIS-
CONNECT THE MAIN POWER SUPPLY CONNECTOR ON THE SIDE OF THE BAT-
TERY STORAGE/CHARGER BOX.
NOTE: The holes in the base frame for mounting the spring clips
and routing the wires through the center crossmember to
the interlock relay may already exist. If not continue with
Step 3, if holes are there, jump to Step 5.
3. Drill two (2) .219 diameter (7/32") holes per side for
each spring clip see Figure 5-2.