JLG 601S Parts Manual - Manual (Page 271)

3120867 601S 7-29
SECTION 7 ELECTRICAL
701C Not Available Shield, Cover
701D Not Available Plug, Male
701E Not Available Cable, Electrical - 12-3
701F Not Available Connector
702 0257887 1 Alarm/Harness Assembly
0140032 1 Alarm
2820035 6in/15cm Loom
702A 4460424 1 Plug
702B 4460268 2 Socket
702C 1 Relay Harness Options: (Not Shown)
4922123 Motion Alarm
4922124 Travel Alarm
703 Not Available 1 Strobe Light Harness
703A 4460320 1 Connector, Female - 2 Position
703B 4460267 2 Pin, Male
704 4933092 Ref Generator Electrical Components) A
3990010 1 Diode - 6 Amp (Not Shown)
704A 4921938 1 Harness - On/Off Switch Options (Powermite Control Box to
Ground Control Box)
704B 4460027 1 110V GFI Receptacle
704C 4460190 1 110V GFI Receptacle
705 4921827 Ref. Generator to Rear of Boom Harness (110V) 1
Ref. Note: Harness used to connect AC at Platform Harness to
Generator Receptacle to power platform receptacle.
1060494 20ft/6.1m Cable, Electrical - 12/3
705A 4460205 1 Plug, Male (110V)
705B 4460134 1 Connector, Female (110V)
706 Not Available 1 Light Harness
3740049 1 Relay (Not Shown)
1060341 37ft/11.3m Cable, Electrical 16/2 (Does not Include terminals)
707 2920140 2 Platform Worklights Harness (Includes Light & Wire Only)
2820035 9ft/2.8m Loom, Vinyl
707A 4460598 1 Connector, Strain Relief
4460042 2 Terminal (Not Shown - Located in Platform Console)
Ref. TOOLS
801 7002821 1 Crimper (For Wire to Pin/Socket Connections)
802 7002823 1 Extractor (For Removal of Pin/Socket from Connectors)
803 4460467 1 Extractor, Pin (Blue 16-18 Gauge) (For Removal of Pin/Socket
from Connectors)
4460510 1 Extractor, Pin (Yellow 12-14 Gauge) (For Removal of Pin/Socket
from Connectors)
804 7002828 1 Stripper, Wire
FIGURE 7-6. HARNESS COMPONENTS INSTALLATION (PRIOR TO S/N 62137) (CONTINUED)
ITEM # PART NUMBER QTY. DESCRIPTION REV.