JLG 120-SXJ Service Manual - Manual (Page 11)

SECTION 1 - SPECIFICATIONS
3121810 – JLG Lift – 1-1
SECTION 1. SPECIFICATIONS
1.1 CAPACITIES
Engine Crankcase
Deutz F4L912 w/Filter - 12.5 liters (13.2 quarts)
Fuel Tank
150 liters (40 gallons)
Hydraulic Tank
189 liters (50 gallons)
1.2 COMPONENT DATA
NOTE: Tolerance on all engine rpm settings is plus or minus
10%.
Engine - Deutz F4L912
Fuel - Diesel
Oil Capacity (crankcase only) - 12 liters (12.7 quarts)
Low (Mid) RPM - 1800
High RPM - 2400
Alternator - 55 Amp
Battery - 1000 cold cranking Amps, 210 minutes reserve
capacity, 12 VDC
Fuel Consumption
Low RPM - 9.1 lph (2.4 gph)
High RPM - 14.2 lph (3.8 gph)
Horsepower - 70 @ 2400 RPM, no load
Torque Hub
Input Torque - 157 Nm (116 ft. lbs.)
Input Speed - 2734 rpm
Output Torque - 13878 Nm (10236 ft. lbs.)
Output Speed - 31 rpm
Static Brake Torque - 200 Nm (147.5 ft. lbs.)
Release Pressure - 18 Bar (261 psi)
Max. Release Pressure - 50 Bar (725 psi)
Drive Motor
Max. Displacement - 45 cc (2.75 in 3 )
Min. Displacement - 15.2 cc (0.93 in
3
)
Output Speed at Max. Displacement - 3000 rpm
Output speed at Min. Displacement - 4000 rpm
1.3 PERFORMANCE DATA - 100SX, 110SX &
110SXJ
Platform Height
100SX - 30.5 m (100ft.)
110SX & 110SXJ - 33.5 m (110 ft.)
Horizontal Outreach
16.7 m (55 ft.)
Below Ground Reach (110SX only)
3.6 m (12 ft.)
Swing
360° Continuous
Platform Capacity - Restricted (100SX &
110SX - Australia Spec Only)
450 kg (1000 lbs.)
Platform Capacity - Unrestricted
230 kg (500 lbs.)
Platform Rotator
180° Hydraulic
Jib Range of Articulation - 110SXJ
3.05 m (10 ft.) 95 degrees (+15, -80)
Overall Width - Axles Retracted
2.49 m (8 ft. 2 in.)
Overall Width - Axles Extended
3.3 m (10 ft. 10 in.)
Tailswing (Axles Extended)
86 cm (2 ft. 10 in.)
Stowed Height
3.0 m (9 ft. 10 in.)
Stowed Length
100SX - 11.55 m (37 ft. 10 in.)
110SX - 11.76 m (38 ft. 7 in.)
110SXJ - 13.46 m (44 ft. 2 in.)