JLG 600SC_660SJC Parts Manual - Manual (Page 147)

3121251 600SC 660SJC 2-101
SECTION 2 TURNTABLE
FIGURE 2-22. 2500W GENERATOR INSTALLATION - CATERPILLAR MACHINES (OPTIONAL)
ITEM # PART NUMBER QTY. DESCRIPTION REV.
Ref. Note: For Module Identification (Non-UGM/UGM), refer to
Revision Log page A.
Ref. GENERATOR INSTALLATION OPTIONS:
Ref. Without UGM
0274081 Ref. 110V/60Hz 1/A
0274091 Ref. 110V/50Hz (S/N 0300128000 to S/N 0300132849) 1/A
1001102547 Ref. 110V/50Hz (S/N 0300132803 to S/N 0300174703) A
0274087 Ref. 220V/50Hz (S/N 0300128000 to S/N 0300132849) 1/A
1001102548 Ref. 220V/50Hz (S/N 0300132803 to S/N 0300174703) A
Ref. With UGM
1001115404 Ref. 110V/60Hz A
1001115413 Ref. 110V/50Hz (S/N 0300128000 to S/N 0300166808) A
1001115414 Ref. 220V/50Hz A
1 3580322 1 Pulley
2 1 Generator and Control Box Assembly Options:
2460055 110V/60Hz
2460057 110V/50Hz S/N 0300128000 to S/N 0300132849
See Note 110V/50Hz S/N 0300132849 to S/N 0300174703
(Note: Not Available for Purchase.)
2460056 220V/50Hz S/N 0300128000 to S/N 0300132849
See Note 220V/50Hz S/N 0300132849 to S/N 0300174703
(Note: Not Available for Purchase.)
2A 7012558 1 Generator Only - 110V/60Hz
2460049 1 Generator Only - 110V/50Hz (was p/n 7019679 &
70000129)
1001100321 1 Generator Only - 220V/50Hz (was p/n 7019679 &
70000128)
Ref. Note: Replacement Generator come standard with
p/n 3580134 pulley. This pulley may not be correct
for all applications. Refer to pulley options below.
1 Armature with Slip Rings Options:
7026199 Armature with Slip Rings - 110V/60Hz
70000122 Armature with Slip Rings - 110V/50Hz
70000123 Armature with Slip Rings - 220V/50Hz
7012513 4 Cap, Brush Holder
7020108 4 Brush
7020109 4 Holder, Brush
7012514 1 Fan
7020110 1 Bell, Front
7020111 1 Bell, Rear
7020190 2 Bearing
2B 7019680 1 Box, Control - 110V/60Hz (was p/n 7003657)
7019680 1 Box, Control - 110V/50Hz (S/N 0300128000 to
S/N 0300132849 Only) (was p/n 7003657)
70000127 1 Box, Control - 220V/50Hz (was p/n 7019680)
(S/N 0300128000 to S/N 0300132849 Only)