Section 2. preparation and inspection, 1 personnel requirements, Operator requirements – JLG LiftPOD FS80 (1001070465) User Manual
Page 19: Decals, instructions, and warnings on the machine, Employer and government regulations, Correct assembly of the machine, Use of approved fall protection device, Specific job requirements or machine application, Operator responsibility, Section - 2 - preparation and inspection
SECTION 2 - PREPARATION AND INSPECTION
LIFTPOD by JLG
1001070465
www.liftpod.com
2-1
SECTION 2. PREPARATION AND INSPECTION
2.1
Personnel Requirements
This machine is a personnel handling device; so it is necessary
that it be operated and maintained by competent personnel.
Persons under the influence of drugs or alcohol or who are subject
to seizures, dizziness or loss of physical control must not operate
this machine.
Operator Requirements
Before operating this machine the operator is required to have
read and understood the Operation, Safety, Service and Mainte-
nance Manual.
The operator must be familiar with:
1. Use and limitations of the controls in the platform and
emergency controls.
2. Decals, instructions, and warnings on the machine.
3. Employer and government regulations.
4. Correct assembly of the machine.
5. Use of approved fall protection device.
6. Enough knowledge of the mechanical operation of the
machine to recognize a malfunction or potential mal-
function.
7. The safest means to operate the machine where over-
head obstructions, other moving equipment, and obsta-
cles, depressions, holes, drop-offs are present.
8. Means to avoid the hazards of unprotected electrical
conductors.
9. Specific job requirements or machine application.
Operator Responsibility
The operator must shut down the machine in case of a malfunc-
tion or other unsafe condition of either the machine or the job site.