JLG LiftPOD FS80 (1001070465) - Manual (Page 74)

SECTION 6 - SERVICE AND MAINTENANCE
1001070465 LIFTPOD by JLG
6-4 www.liftpod.com
Reference the appropriate areas of this manual for servicing and
maintenance procedures.
5 Year Machine Inspection & Rope Replacement
The mast and carriage module must be inspected and the ropes
replaced by an Authorized JLG Service Center when:
• The rope is worn beyond specification (see Figure 2-4.);
• A rope is tangled, damaged or broken;
• When the machine has been in service for 5 years.
NOTICE
IT IS IMPORTANT THAT JLG HAS UPDATED OWNERSHIP INFORMATION
FOR EACH MACHINE COMPONENT. WHEN PERFORMING EACH ANNUAL
MACHINE INSPECTION, NOTIFY JLG OF THE CURRENT MACHINE COM-
PONENT OWNERSHIP.
Preventive Maintenance
In conjunction with the specified inspections, maintenance shall
be performed by a competent person such as a qualified JLG
equipment mechanic.
6.3 PREVENTIVE MAINTENANCE AND
INSPECTION SCHEDULE
The preventive maintenance and inspection checks are listed and
defined in the following table. This table is divided into two basic
parts, the "AREA" to be inspected and the "INTERVAL" at which the
inspection is to take place. Under the "AREA" portion of the table,
the various systems along with the components that make up that
system are listed. The "INTERVAL" portion of the table is divided
into four columns representing the various inspection time peri-
ods. The numbers listed within the interval column represent the
applicable inspection code for which that component is to be
checked.
The checks and services listed in this schedule are not intended to
replace any local or regional regulations that may pertain to this
type of equipment nor should the lists be considered as all inclu-
sive. Variances in interval times may occur due to climate and/or
conditions and depending on the location and use of the machine.