JLG LiftPOD FS80 (1001070465) - Manual (Page 83)

SECTION 6 - SERVICE AND MAINTENANCE
LIFTPOD by JLG 1001070465
www.liftpod.com 6-13
• Country Kit - Slovenian (JLG Part No. 1001070567)
• Country Kit - Maltese (JLG Part No. 1001070568)
• Country Kit - Romanian (JLG Part No. 1001070569)
• Country Kit - Bulgarian (JLG Part No. 1001070570)
• Country Kit - Russian (JLG Part No. 1001070570)
• Country Kit - Australian (JLG Part No. 1001070572)
Leads
NOTE: Following items refer to the AC Leads (not pictured).
• AC Lead - 220V UK Blue (JLG Part No. 1001071685)
• AC Lead - 110V UK Yellow (JLG Part No. 1001071688)
• AC Lead - 220V Mainland Europe (JLG Part No.
1001071693)
• AC Lead - 220V Denmark (JLG Part No. 1001071694)
• AC Lead - 220V UK 3 Pin Domestic (JLG Part No.
1001071695)
• AC Lead - 240V Australia (JLG Part No. 1001070573)
6.6 Decal Replacement
All decals must be mounted to the machine as specified and be
clearly legible.
Please see Figure 5-1. to Figure 5-4 and refer to Table 5-1. for
positions and JLG part numbers.
To replace a damaged decal, first remove it completely, without
damaging the underlying surface.
Remove any remaining adhesive with a suitable solvent. Test sol-
vent on inconspicuous area first, to ensure it does not mark or
damage the underlying surface finish.
NOTICE
SURFACE DAMAGE COULD RESULT IN CORROSION AND STRUCTURAL
DAMAGE.
Before applying new decal, ensure the surface is clean and dry.
Remove backing paper, apply decal along one edge then seat it
gently and evenly.
If there are any air bubbles, work them gently towards the edge
with a clean cloth.
Pressure sensitive adhesive reaches full strength after a several
days.