14 dual fuel system (gas engine only), Changing from gasoline to lp gas, Changing from lp gas to gasoline – JLG 660SJ Operator Manual User Manual

Page 73: 15 hydraulic tool circuit instructions, Tool circuit, 14 dual fuel system (gas engine only) -15, 15 hydraulic tool circuit instructions -15, Tool circuit -15

Advertising
background image

SECTION 4 - MACHINE OPERATION

3121205

– JLG Lift –

4-15

4.14 DUAL FUEL SYSTEM (GAS ENGINE ONLY)

The dual fuel system enables the standard gasoline engine
to run on either gasoline or LP gas.

IT IS POSSIBLE TO SWITCH FROM ONE FUEL SOURCE TO THE OTHER
WITHOUT ALLOWING THE ENGINE TO STOP. EXTREME CARE MUST BE
TAKEN AND THE FOLLOWING INSTRUCTIONS MUST BE FOLLOWED.

Changing From Gasoline to LP Gas

1. Start engine from Ground Control Station.

2. Open hand valve on LP gas supply tank by turning

counterclockwise.

3. While engine is operating on GASOLINE under a no-

load condition, place FUEL SELECT switch at Platform
Control to LP position.

Changing From LP Gas to Gasoline

1. With engine operating on LP under a no-load condition,

position FUEL SELECT switch at Platform Control Sta-
tion to GASOLINE position.

2. Close hand valve on LP gas supply tank by turning

clockwise.

4.15 HYDRAULIC TOOL CIRCUIT INSTRUCTIONS

Tool Circuit

Operate with engine running and foot switch released.

1. Be sure hydraulic switch is “OFF”. It is located on the left

side of platform below console box.

Advertising
This manual is related to the following products: