JLG G5-18A Service Manual - Manual (Page 42)

Cab and Covers
4.6 G5-18A/2505
b. Throttle Pedal Installation
1. Align the throttle pedal assembly with its mount
holes under the cab dash.
2. Install three capscrews securing the throttle pedal
assembly to the mount. Torque the capscrews to
9 lb-ft (12 Nm).
3. Tighten the hex jam nut and flat washer (1) securing
the throttle cable to the throttle pedal assembly.
4. Install the nut to the end of the throttle cable (2).
5. Connect the battery negative (-) cable to the battery
negative (-) terminal.
6. Close and secure the engine cover.
c. Throttle Adjustment
1. From within the cab, lightly depress the accelerator
pedal (3) to the full-throttle position.
2. With the accelerator pedal held in the full throttle
position, check the throttle position on the fuel injector
pump on the engine. The throttle lever should be
bottomed against the limit-stop screw.
3. If there is an adjustment needed, return to the cab
and adjust the throttle cable (4) so the lever on the
fuel injector pump bottoms against the limit-stop just
before the throttle pedal bottoms against the limit-
stop (5) in the cab.
4. Check the engine rpm at full throttle. If the rpm is not
2370 ±50 rpm, readjust the throttle cable at the
throttle pedal within the cab.
MY2360
2
1 5
3
4
NOTICE
During the full throttle check:
• DO NOT operate any hydraulic function.
• DO NOT steer or apply any pressure to the
steering wheel.
• Keep the transmission in (N) NEUTRAL.