JLG 600A_AJ Parts Manual - Manual (Page 276)

7-42 3120841
SECTION 7 ELECTRICAL
S
E
C
T
I
O
N
7
E
L
E
C
T
R
I
C
A
L
807 4921957 Generator to Rear of Boom Harness (110V/220V) 1
Note: Harness used to connect AC at platform
harness to generator receptacle to power plat-
form receptacle. Ref.
1060461 Cable, Electrical - 12/3 6ft/1.8m
807A Not Required Plug, Male 1
807B Not Required Receptacle, Female 1
808 See Note Lights Harness (Note: Not Available for Purchase) 1
1060341 Cable, Electrical - 16/2 37ft/11.3m
808A 3740049 Relay 1
808B 4922643 Harness, Bag (Located at Ground Control Box)
(Not Shown) 1
809 2920140 Platform Worklights Harness (Includes Light and
Wire Only) 2
2820035 Loom, Vinyl 9ft/2.8m
7016399 Bulb, Replacement (50 watts) (1 Per) 1
809A 4460598 Connector, Strain Relief 1
809B 4360232 Circuit Breaker, 15Amp 1
810 See Note Soft-Touch System Harness (Note: Not Available
for Purchase) 1
810A 1060341 Cable, Electrical - 16/3 16ft/4.9m
810B 4460425 Connector, Strain Relief 1
TOOLS Ref.
901 7002821 Crimper (For Wire to Pin/Socket Connections) 1
902 7002823 Extractor (For Removal of Pin/Socket from Connec-
tors) 1
903 4460467 Extractor, Pin (Blue 16-18 Gauge) (For Removal of
Pin/Socket from Connectors) 1
4460510 Extractor, Pin (Yellow 12-14 Gauge) (For Removal of
Pin/Socket from Connectors) 1
904 7002828 Stripper, Wire 1
905 1001137005 Software Cable Kit (Not Shown) 1
FIGURE 7-8. HARNESS COMPONENTS INSTALLATION (WITH ADE SYSTEM) (S/N 0300064249 TO
S/N 0300064270) (CONTINUED)
FIG & ITEM # PART NUMBER DESCRIPTION QTY. REV.