JLG 1100SB Parts Manual - Manual (Page 43)

3121266 1100SB 2-11
SECTION 2 TURNTABLE
FIGURE 2-3. TURNTABLE SWING DRIVE AND BEARING INSTALLATION
ITEM # PART NUMBER QTY. DESCRIPTION REV.
0271596 Ref SWING DRIVE INSTALLATION D
1 0100019 AR Compound, Locking
2 0682418 5 Bolt 7/8in- 9NC x 2-1/4in (Grade 8)
3 1 Swing Motor/Hub Assembly Options (See SWING MOTOR/HUB
ASSEMBLY for Breakdown)
Use 1001134098 Prior to SN 0300074374 (was p/n 3160281 & p/n 3160302)
Use 1001134098 SN 0300074374 to SN 0300152138 (was p/n 3160302)
Use 1001134098 SN 0300152138 to Present
4 3312002 1 Nut, Jam 5/8in-11NC
5 3900223 1 Screw, Shoulder
6 3952020 1 Setscrew 5/8in-11NC x 2-1/2in
7 4071041 1 Shim
8 4892400 5 Flatwasher 7/8in Hardened
0271512 Ref TURNTABLE BEARING AND LUBE INSTALLATION B
101 0100019 AR Compound, Locking
102 Use 2915072 1 Bearing Kit (was p/n 0440251) (Kit Includes Bearing & Mounting
Hardware)
103 0682026 40 Bolt 5/8in-11NC x 3-1/4in (Grade 8)
104 0682040 40 Bolt 5/8in-11NC x 5in (Grade 8)
105 2180002 2 Fitting, Grease
106 2180344 2 Fitting, Bulkhead
107 2220063 2 Fitting, Adapter
108 Not Used
109 2750528 2 Hose
110 4892000 80 Flatwasher 5/8in Hardened
0239842 Ref TURNTABLE LOCK INSTALLATION B
201 Not Used
202 3421565 1 Pin, Snap
203 1260017 9 in/23cm Chain - #3
204 3760170 2 Ring, Quick Release
205 3421563 1 Pin, Turntable Lock
Ref TURNTABLE WELDMENT OPTIONS:
4620149 Ref Machines with ABS Hoods (SN 0300073745 Only)
1001107391 Ref Machines with Steel Hoods