JLG G6-23A Operator Manual - Manual (Page 106)

Section 7 - Lubrication and Maintenance
7-14 31200192
Tires
A. Tire Air Pressure Check
1. Perform “Shut-Down Procedure” on page 4-3.
2. Remove valve stem cap.
3. Check tire pressure using a good quality gauge.
4. Add air if required.
405/70-24 (G6-23A) ...........................................................58 psi (4 bar)
405/70-20 (G5-19A) ...........................................................51 psi (3,5 bar)
5. Replace valve stem cap.
B. Tire Damage
For pneumatic tires, JLG recommends that when any cut, rip or tear is discovered
that exposes sidewall or tread area cords in the tire, measures be taken to remove
the JLG product from service immediately. Arrangements must be made for
replacement of the tire or tire assembly.
For polyurethane foam filled tires, JLG recommends that when any of the following
are discovered, measures must be taken to remove the product from service
immediately. Arrangements must be made for replacement of the tire or tire
assembly.
• A smooth even cut through the cord piles which exceeds 3 in (7,5 cm) in total
length.
• Any tears or rips (ragged edges) in the cord plies which exceeds 1 in (2,5 cm) in
any direction
• Any punctures which exceed 1 in (2,5 cm) in diameter.
If a tire is damaged but within the above noted criteria, the tire must be inspected
daily to ensure the damage has not propagated beyond the allowable criteria.
8
OW1150
OW1040