JLG G6-23A Operator Manual - Manual (Page 81)

Section 5 - Attachments
5-17 31200192
To Side Tilt:
• Use the button (3) to select the auxiliary hydraulic circuit.
• Press joystick button (4) to side tilt carriage right or press joystick button (5) to
side tilt carriage left.
OR
• While pressing and holding the joystick button (6), move the joystick forward (7)
to side tilt carriage right or move the joystick back (8) to side tilt carriage left.
Installation Procedure:
• Refer to “Attachment Installation” on page 5-7.
Operation:
• Approach load with forks centered on load and stop telehandler.
• Level telehandler before side tilting carriage to engage load.
• Side tilt carriage to left or right to align forks with load and engage load.
• Raise load slightly and then level carriage side to side.
• Travel in accordance with requirements set forth in Section 1 - General Safety
Practices.
WARNING
CRUSH HAZARD. Do not use side shift to push or pull objects or load. Failure to
comply could cause object or load to fall resulting in death or serious injury.
OAH1010
3
6
4
5
7
8