JLG 19BD Operator Manual - Manual (Page 39)

SECTION 5 - OPTIONAL EQUIPMENT
3121153 – JLG Lift – 5-1
SECTION 5. OPTIONAL EQUIPMENT
5.1 OPTIONAL EQUIPMENT
The following optional equipment is available for 15BD model
machines:
28" x 26" Front Entry Gullwing Platform
The 28" (71cm) long by 26" (66cm) wide platform features a gull
wing gate opening.
Tool/Bottle Tray
Platform attachment to hold hand tools or other small items
placed in the tray.
Platform Foot Control Switch
This is a dual footswitch operated control that is mounted on the
floor of the platform. These switches in conjunction with the
function enable switch (GREEN) on the platform control panel,
allows control of the UP (raising) and Down (lowering) of the
platform.
Tube Carrier (PVC)
These carriers are mounted to the right side of the mast assem-
bly, just behind the platform rail. They are approximately 3.5 in
in diameter and are approx. 45 inches in length and allow for
storage of materials that may be required while working in the
platform.
18 Ft. Height Limiter - (19BD ONLY - OPTION)
The platform limiter switch when installed on the 19BD model
lift, limits the platform to a maximum height of 18 ft. This can be
useful when platform height must be limited due to ceiling
height, or a specific work height is required.
Platform Gate Interlock - (OPTION)
If equipped, the optional platform gate interlock will pre-
vent the platform lift function from operating with either
gate open.
NOTE: To verify if the machine is equipped with the optional gate
interlocks, look for a wire harness to exit the platform mid-
rail through a small hole in the midrail near the mast
header.