JLG 19BD Operator Manual - Manual (Page 27)

SECTION 3 - MACHINE CONTROLS AND INDICATORS
3121153 – JLG Lift – 3-1
SECTION 3. MACHINE CONTROLS AND INDICATORS
3.1 GENERAL
NOTICE
THE MANUFACTURER HAS NO DIRECT CONTROL OVER MACHINE
APPLICATION AND OPERATION. THE USER AND OPERATOR ARE
RESPONSIBLE FOR CONFORMING WITH GOOD SAFETY PRACTICES.
This section provides the necessary information needed to under-
stand control functions.
3.2 CONTROLS AND INDICATORS
Ground Control Station (See Figure 3-1.)
1. POWER ON/OFF Key Switch
A key switch located on the ground control station con-
trols power to all functions on the machine. The machine
will not operate without the key inserted and turned to the
ON position. When left unattended, removing the key will
prevent unauthorized operaton.
2. EMERGENCY STOP SWITCH
A two position mushroom shaped switch furnishes power
to the platform and ground controls when RESET (ON).
When pushed in (OFF), power is shut off to the platform
and ground controls.
3. HYDRAULIC RESERVOIR/CIRCUIT BREAKER/FUSE
(located inside the ground control station housing)
The hydraulic oil level can be checked through an access
hole in the side of the cover.
NOTE: Check hydraulic oil only when platform is completely low-
ered and after cycling platform up/down a few times.
NOTE: A replaceable 5 Amp fuse for the DC Voltage circuit and a
reset type circuit breaker for the AC Voltage circuit is
located in the AC Junction Box on BD Models.
4. HOURMETER
The machine hourmeter registers pump operation time
during the platform LIFT UP cycle only. The hourmeter is
located on the back of the Ground Control Station on the
pump mounting bracket.