JLG 19BD Operator Manual - Manual (Page 41)

SECTION 6 - EMERGENCY PROCEDURES
3121153 – JLG Lift – 6-1
SECTION 6. EMERGENCY PROCEDURES
6.1 GENERAL INFORMATION
This section explains the steps to be taken in case of an emer-
gency situation while operating the machine.
6.2 EMERGENCY OPERATION
Operator Unable to Control Machine
IF THE PLATFORM OPERATOR IS PINNED, TRAPPED OR
UNABLE TO OPERATE OR CONTROL THE MACHINE, USE THE
FOLLOWING INSTRUCTIONS AS A GUIDELINE. DO NOT CON-
TINUE OPERATION IF CONTROLS DO NOT FUNCTION PROP-
ERLY
1. If the operator is unable to lower the platform from the
platform controls, other personnel should operate the
emergency descent control valve located at the rear of
the machines base frame, “Manual Descent Valve Loca-
tion” on page 3-2, to lower the platform.
2. If necessary, rescue equipment can be used to remove
the platform occupant and stabilize motion of the
machine.
Platform Caught Overhead
If the platform becomes jammed or snagged in overhead struc-
tures or equipment, rescue the platform occupant prior to freeing
the machine.
6.3 INCIDENT NOTIFICATION
JLG Industries, Inc. must be notified immediately of any incident
involving a JLG product. Even if no injury or property damage is
evident, the factory should be contacted by telephone and pro-
vided with all necessary details.
JLG Phone: USA: 877-JLG-SAFE (554-7233)
(8am till 4:45pm EST)
Email (USA): [email protected]
Failure to notify the Manufacturer of an incident involving a JLG
Industries product within 48 hours of such an occurrence may
void any warranty consideration on that particular machine.
NOTICE
FOLLOWING ANY INCIDENT, THOROUGHLY INSPECT THE MACHINE
AND TEST ALL FUNCTIONS. DO NOT ELEVATE PLATFORM UNTIL YOU
ARE SURE THAT ALL DAMAGE HAS BEEN REPAIRED, IF REQUIRED,
AND THAT ALL CONTROLS ARE OPERATING CORRECTLY.