JLG 15VPSP Operator Manual - Manual (Page 45)

SECTION 5 - OPTIONAL EQUIPMENT
3120796 – JLG Lift – 5-5
9. Remove the rug from the Rug Carrier Accessory. As
required, use an assistant to unload the rug from the
Rug Carrier Accessory Arms.
10. Stow the Rug Hanger Accessory arms.
THE RUG CARRIER ACCESSORY ARMS MUST BE LOCKED IN
THE STOWED POSITION WHEN NOT IN USE.
EXTREME CAUTION MUST BE EXERCISED AT ALL TIMES WHILE
THE RUG CARRIER ACCESSORY IS IN USE (DRIVING, RAISING
AND LOWERING) TO PREVENT OBSTACLES AND PERSONNEL
FROM STRIKING THE LOAD.
WHEN DRIVING WITH A RUG WITHIN THE RUG CARRIER ACCES-
SORY, THE RUG MUST BE PROPERLY SECURED SO AS TO PRE-
VENT INADVERTENT MOTION OR MOVEMENT OF THE RUG AND
MUST NOT EXCEED THE RATED CAPACITY OF THE RUG CAR-
RIER ACCESSORY.
NEVER OVERLOAD THE RUG CARRIER ACCESSORY. MAXIMUM
CAPACITY OF THE RUG CARRIER ACCESSORY IS 150 LBS. AND
THE MAXIMUM CAPACITY OF THE PLATFORM IS 500 LBS.
INCLUDING PERSONNEL, MATERIALS, EQUIPMENT AND ANY
LOAD ON THE RUG CARRIER ACCESSORY.
NEVER USE A RUG CARRIER ACCESSORY THAT IS DAMAGED
OR HAS LOOSE MOUNTINGS. IMMEDIATELY REPORT ANY DAM-
AGE TO APPROPRIATE PERSONNEL. DISCONTINUE USE OF
THE RUG CARRIER ACCESSORY UNTIL ALL DISCREPANCIES
HAVE BEEN CORRECTED.
5.4 PROGAMMABLE SECURITY LOCK
(PSL
™ )
The optional keyless Programmable Security Lock switch
can be programmed with a four (4) digit operators code
to allow only those persons with the code to start and
operate the machine.
PSL ™ Box and Ground Control Locations
Figure 5-6. Removing Rug From Display Arm.
ROLL RUG
RUG CARRIER ARM
Figure 5-7. PSL
™
Switch & Ground Control Station
Locations - At Rear of Machine.
Figure 5-8. PSL
™
Switch Controls & Indicators.
PROGRAMMABLE
SECURITY
LOCK
GROUND
CONTROL
STATION
ON
ACCEPT
PROGRAM
PSL ™
P
R
O
G
A
M
M
A
B
L
E
S
E
C
U
R
I
T
Y
L
O
C
K
1 2 3
4 5 6
7 8 9
0 ON OFF
KEY
PAD
LED
INDICATORS
GREEN - ON
AMBER - ACCEPT
RED - PROGRAM