JLG 3248RS/10RS Operator Manual - Manual (Page 28)

SECTION 2 - USER RESPONSIBILITIES, MACHINE PREPARATION AND INSPECTION
2-6 – JLG Lift – 3121272
2.4 DAILY WALK-AROUND INSPECTION
Begin the “Walk-Around Inspection” at item 1, see Figure 2-1. on
page 3-7. Continue checking each item in sequence for the conditions
listed in the following checklist.
TO AVOID POSSIBLE INJURY, BE SURE MACHINE POWER IS “OFF”. DO NOT
OPERATE UNTIL ALL MALFUNCTIONS HAVE BEEN CORRECTED.
NOTICE
DO NOT OVERLOOK VISUAL INSPECTION OF CHASSIS UNDERSIDE. CHECKING
THIS AREA MAY RESULT IN DISCOVERY OF CONDITIONS WHICH COULD CAUSE
EXTENSIVE MACHINE DAMAGE.
INSPECTION NOTE: On all components, make sure there are no loose or
missing parts, that they are securely fastened, and that no visible dam-
age, leaks or excessive wear exists in addition to any other criteria men-
tioned.
1. Frame/Chassis - See Inspection Note. Ensure that passive pot-
hole components on frame are in place, undamaged, not
bent or worn.
2. Ground Controls - Placard secure and legible, control
switches return to neutral position, emergency stop switch
functions properly. Control markings legible.
3. Hydraulic Pump/Motor, Control Valve Installation - No
unsupported wires or hoses; no damaged or broken wires -
See Inspection Note.
4. Front Wheels - Steer linkage, and Steer Cylinder - See Inspec-
tion Note.
5. Battery Compartment - See Inspection Note.
6. Rear Wheels, Tires and Drive Motors - Properly secured, no
missing lug nuts. Refer to Section 5.7, TIRES AND WHEELS.
Inspect wheels for damage and corrosion - See Inspection
Note.
7. Manual Descent Control - See Inspection Note.
8. Beacon (if equipped) - See Inspection Note.
9. Scissor Arms, Pivot Pins and Sliding Wear Pads, Lift Cylinder -
See Inspection Note.
10. Platform/Handrail/Gate Installation - Deck extension slides
in and out and locks in place properly. Gate closes properly.
All fold-down rail pins in place and secure (3248RS/10RS and
6RS CE ONLY) - See Inspection Note.
11. Platform Control Console - Ensure that the control console is
firmly secured in the proper location. Placards secure and
legible, control lever and switches return to neutral, and
emergency stop switch function properly, required manuals
in storage box.