JLG 3248RS/10RS Operator Manual User Manual
Operation and safety manual, Ansi
Advertising
This manual is related to the following products:
Table of contents
Document Outline
- SECTION 1. FOREWORD
- SECTION 2. SAFETY ALERT SYMBOLS AND SAFETY SIGNAL WORDS
- SECTION 3. REVISION LOG
- SECTION 1. SAFETY PRECAUTIONS
- SECTION 2. USER RESPONSIBILITIES, MACHINE PREPARATION AND INSPECTION
- SECTION 3. MACHINE CONTROLS, INDICATORS AND OPERATION
- 3.1 GENERAL
- 3.2 DESCRIPTION
- 3.3 OPERATING CHARACTERISTICS AND LIMITATIONS
- 3.4 PLATFORM LOADING
- 3.5 MACHINE CONTROL LOCATIONS
- 3.6 GROUND CONTROL STATION
- 3.7 PLATFORM CONTROL STATION
- Platform Emergency Stop Switch - (Item 8 - Figure 3-6.)
- Lift/Drive Select - (Item 10 - Figure 3-6.)
- Forward/Reverse/Lift/Lower Direction Decal - (Item 4 - Figure 3-6.)
- Drive/Lift/Steer Joystick Control
- Steering And Traveling
- Steering
- Traveling Forward and Reverse
- Raising And Lowering Platform
- Arm Guards
- Overload Indicator (If Equipped) - (Item 6 - Figure 3-6.)
- Tilt Indicator Warning Light and Alarm - (Item 7 - Figure 3-6.)
- Horn - (Item 9 - Figure 3-6.)
- Low Battery Charge and System Fault Indicator - (Item 11 - Figure 3-6.)
- Alarm - (Item 5 - Figure 3-6.)
- 3.8 PLATFORM EXTENSION
- 3.9 PLATFORM RAILS - FOLD-DOWN PROCEDURE - (3248RS/10RS and 6RS-CE Only)
- 3.10 BATTERY CHARGING
- 3.11 DC TO AC INVERTER OPERATION (OPTION)
- 3.12 PARKING AND STOWING MACHINE
- 3.13 SCISSOR ARM - SAFETY PROP
- 3.14 MACHINE LIFTING AND TIE DOWN
- 3.15 TOWING
- SECTION 4. EMERGENCY PROCEDURES
- SECTION 5. GENERAL SPECIFICATIONS AND MAINTENANCE
- 5.1 INTRODUCTION
- 5.2 OPERATING SPECIFICATIONS
- 5.3 CRITICAL STABILITY WEIGHTS
- 5.4 LUBRICATION
- 5.5 MAINTENANCE
- 5.6 BATTERY MAINTENANCE
- 5.7 TIRES AND WHEELS
- 5.8 DECAL INSTALLATION
- 5.9 DIAGNOSTIC TROUBLE CODES (DTC)
- 5.10 DTC CHECK TABLE INDEX
- 5.11 DIAGNOSTIC TROUBLE CODES (DTC) CHECK TABLES
- 0-0 Help Comments
- 2-1 Power-Up
- 2-2 Platform Controls
- 2-3 Ground Controls
- 2-5 Function Prevented
- 3-1 Line Contactor Open Circuit
- 3-2 Line Contactor Short Circuit
- 3-3 Ground Output Driver
- 4-2 Thermal Limit (SOA)
- 4-4 Battery Supply
- 6-6 Communication
- 7-7 Electric Motor
- 8-2 LSS - Load Sensing System
- 8-4 Elevation Switch
- 9-9 Hardware
- SECTION 6. INSPECTION AND REPAIR LOG