JLG 3248RS/10RS Operator Manual - Manual (Page 82)

SECTION 5 - GENERAL SPECIFICATIONS AND MAINTENANCE
5-18 – JLG Lift – 3121272
5.11 DIAGNOSTIC TROUBLE CODES (DTC) CHECK TABLES
0-0 Help Comments
DTC FAULT MESSAGE DESCRIPTION CHECK
001 EVERYTHING OK The normal help message in platform mode.
Displays on the analyzer only.
002 GROUND MODE OK The normal help message in ground mode.
Displays on the analyzer only.
004 DRIVING AT CUTBACK - ABOVE ELEVA-
TION The platform is elevated and the machine is in
the driving in creep speed. • Fully stow the platform.
• Check that the elevation sensor is securely mounted.
Refer problem to a qualified JLG mechanic.
005 DRIVE & LIFT UP PREVENTED - TILTED &
ELEVATED Driving is not possible since the platform is
elevated and the chassis is not level. • Check that the machine is tilted. If so, lower the platform and reposition the
machine to a level surface.
• Fully stow the platform.
• Check that the tilt sensor is securely mounted.
• Check that the elevation sensor is securely mounted.
Refer problem to a qualified JLG mechanic.
008 FUNCTIONS LOCKED OUT - SYSTEM
POWERED DOWN After 2 hours without activity, the control sys-
tem enters a low-power state to preserve bat-
tery charge. • Normal operation should resume after power is cycled off then back on.
• Check batteries charge, condition, etc.
Refer problem to a qualified JLG mechanic.