JLG 3248RS/10RS Operator Manual - Manual (Page 83)

SECTION 5 - GENERAL SPECIFICATIONS AND MAINTENANCE
3121272 – JLG Lift – 5-19
2-1 Power-Up
DTC FAULT MESSAGE DESCRIPTION CHECK
211 POWER CYCLE This help message is issued at each power
cycle. Displays on the analyzer only. Normal operation. No check necessary.
2-2 Platform Controls
DTC FAULT MESSAGE DESCRIPTION CHECK
221 FUNCTION PROBLEM - HORN PERMA-
NENTLY SELECTED The horn switch was closed during power-up
in platform mode. • Check if the horn switch is damaged, obstructed or jammed.
Refer problem to a qualified JLG mechanic.
223 FUNCTION PROBLEM - DRIVE & LIFT
ACTIVE TOGETHER The drive and lift inputs are closed simultane-
ously in platform mode. • Check drive/lift switch for visible damage.
Refer problem to a qualified JLG mechanic.
224 FUNCTION PROBLEM - STEER LEFT PER-
MANENTLY SELECTED The steer left switch was closed during power-
up in platform mode. • Check if the steer left switch is obstructed or jammed.
Refer problem to a qualified JLG mechanic.
225 FUNCTION PROBLEM - STEER RIGHT
PERMANENTLY SELECTED The steer right switch was closed during
power-up in platform mode. • Check if the steer right switch is obstructed or jammed.
Refer problem to a qualified JLG mechanic.
226 ACCELERATOR FAULTY - WIPER OUT OF
RANGE There is a problem with the joystick. • Center joystick and check to see if a power cycle will clear DTC.
Refer problem to a qualified JLG mechanic.
227 STEER SWITCHES FAULTY The steer left and steer right inputs were
closed simultaneously. • Check if the steer switches are damaged, obstructed or jammed.
Refer problem to a qualified JLG mechanic.