JLG 3248RS/10RS Operator Manual - Manual (Page 92)

SECTION 5 - GENERAL SPECIFICATIONS AND MAINTENANCE
5-28 – JLG Lift – 3121272
8215 LSS ANGLE SENSOR -
OUT OF RANGE LOW
The angle sensor’s reading when the machine
is stowed does not fall within the low end
acceptable range. Refer problem to a qualified JLG mechanic.
8216 LSS ANGLE SENSOR HAS NOT BEEN CAL-
IBRATED
The Angle Sensor has never been calibrated
and the control system assumes that the plat-
form is overloaded. Refer problem to a qualified JLG mechanic.
8-2 LSS - Load Sensing System
DTC FAULT MESSAGE DESCRIPTION CHECK
8-4 Elevation Switch
DTC FAULT MESSAGE DESCRIPTION CHECK
84109 ELEVATION SWITCH CONTACTS DIS-
AGREEMENT
The elevation switch is repeating an incorrect
value. Refer problem to a qualified JLG mechanic.
9-9 Hardware
DTC FAULT MESSAGE DESCRIPTION CHECK
995 POWER MODULE FAILURE - PERSONAL-
ITY RANGE ERROR A problem has been detected with the power
module. Refer problem to a qualified JLG mechanic.
996 POWER MODULE FAILURE - INTERNAL
ERROR A problem has been detected with the power
module. Refer problem to a qualified JLG mechanic.