JLG 3248RS/10RS Operator Manual - Manual (Page 47)

SECTION 3 - MACHINE CONTROLS, INDICATORS AND OPERATION
3121272 – JLG Lift – 3-15
Tilt Indicator Warning Light and Alarm -
(Item 7 - Figure 3-6.)
A red warning light on the control panel illumi-
nates and an audible alarm sounds when the
chassis is at or beyond the tilt cutout settings.
IF THE TILT INDICATOR WARNING LIGHT/ALARM IS ACTIVATED WHEN PLAT-
FORM IS RAISED LOWER PLATFORM AND DRIVE TO A SMOOTH FIRM LEVEL
SURFACE.
Horn - (Item 9 - Figure 3-6.)
This push-button switch, when pressed, permits
the operator to warn job site personnel when the
machine is operating in the area.
Low Battery Charge and System Fault
Indicator
- (Item 11 - Figure 3-6.)
This indicator light comes on and stays lit when
the battery charge level is very low, indicating
the batteries will need recharging soon.
When indicator light is flashing a system fault
has occurred, possibly stopping machine opera-
tion. Check the MDI indicator on the Ground Control Station to see if a
(DTC) Diagnostic Trouble Code(s) is displayed. An explanation of DTC
codes is shown in Section 5.9.
If the code cannot be cleared by the operator, the machine will require
service by a qualified JLG mechanic.
Alarm
- (Item 5 - Figure 3-6.)
This alarm mounted on the front of the platform control station will
sound for various machine conditions or warnings such as, system
ready chirp or if the machine tilt warning is activated.