JLG 3248RS/10RS Operator Manual - Manual (Page 48)

SECTION 3 - MACHINE CONTROLS, INDICATORS AND OPERATION
3-16 – JLG Lift – 3121272
3.8 PLATFORM EXTENSION
(See Figure 3-9.)
This machine is equipped with an extension deck, giving the operator
better access to certain work areas. The deck extension adds length to
the front of the platform.
FOR MAXIMUM CAPACITY OF THE DECK EXTENSION SEE SECTION 5, Table 5-2
OR REFER TO THE CAPACITY PLACARD ON THE PLATFORM BILLBOARD.
DO NOT “LOWER” WITHOUT COMPLETELY RETRACTING THE PLATFORM
EXTENSION.
To extend the deck:
1. Pull up on the locking pin (1) on left side mid-rail near the
front of the machine. Rotate pin 90° to hold in up position.
2. Grasp the top handrails (2) of the extendible deck and push
the extension out until it hits the stops.
3. Re-engage the locking pin (1) and move platform exten-
sion in or out until the locking pin engages.
To retract the deck:
1. Pull up on the mid-rail locking pin (1) and turn the pin 90°
to hold in up position.
2. Pull the extension deck all the way back into the main deck
using the top handrail (2).
3. Re-engage the mid-rail locking pin (1) back to the locked
position and engage the hole in the mid-rail.
Figure 3-9. Platform Deck Extension
1
2